Energy saving fluorescent tubes with electronic ballasts , compact tubes , and separately controlled lighting circuits for perimeter and interior zones are used for the lighting system 照明裝置采用了省電熒光管配電子鎮流器、慳電燈膽,并將周邊和內部區域的照明裝置開關控制分開。
The difference between the method that the sum and the subtraction of two - arm currents are separately controlled and the method that two - arm currents are separately controlled is discussed , and the later method which is more simple and accurate is selected 比較了總電流與差電流單獨控制和兩臂電流單獨控制這兩種穩流方案的異同,從工程角度選擇了一種較易實現和精度高的方案。
( 2 ) a fuzzy - neural network multiple - variable control algorithm has been brought forward . it separately controls the two loops at the side of the boiler and at the side of the turbine , eliminates or reduces the coupling of each loop by the single - layer neural network ( 2 )提出了一種基于rbf神經網絡的模糊神經網絡多變量控制算法,分別對鍋爐側和汽機側兩個回路進行控制,并通過一個單層神經網絡的協調級來消除和減小各回路的耦合影響。
The author ' s main contributions are outlined as following : first , the roles of hot electron and hole in dielectric breakdown of ultra - thin gate oxides have been quantitatively investigated by separately controlling the amounts of hot electron and hot hole injection using substrate hot hole ( shh ) injection method . the changes of threshold voltage have been discussed under different stress conditions 主要研究結果如下:首先,利用襯底熱空穴( shh )注入技術分別控制注入到超薄柵氧化層中的熱電子和空穴的數量,定量研究了熱電子和空穴注入對超薄柵氧化層擊穿的影響,討論了不同應力條件下的閾值電壓變化。
It elaborates on the 3 - step start technique . i adopt the method which permits the bldc motor to automatically search the best time to change its operation stage from a separately controlled synchronous one to a self controlled one using the back emf as the commutation signal . this method prevents the stepping out and stopping problems in the changing procedure of the motor 闡述了電機的三段式起動方法,在直流無刷電機由起動階段外同步運行切換到反電勢換向自同步運行的過程中采用了自尋最優點切換的方法,保證了電機在切換過程中不會發生失步和停轉現象。